- Posts: 1
- Joined: Jan 2018
I’m thincking about buildnig a neck-through guitar with the kiesel NT7 neck, however, when I look at the measurements I see that the necks body is only 1.72” thick and all body blands I can find are 1.75” thick... Have anybody else tried to build with these? If so, how did you solve the problem?
I’m thinging abuot using sandpaper but I’m worried that the surface wont stay sraight and becoming uneven...
- Posts: 49
- Joined: Feb 2007
- Location: Snohomish, Wa
- Elite Carvinite
- Posts: 15554
- Joined: Jan 2008
- Location: San Francisco Bay Area
japhy wrote:Agreed - borrowing a planer is your best bet. If you have a drill press you can also use a Safe-T planer (can’t link from my phone; google it) as a way of thinning it out, though you should be prepared to sand smooth with the Safe-T planer. But having a friend who works for a large roofing/general contractor company and has access to an industrial scale production shop is the best way to go.
Drill presses hate lateral pressure, unless it's one of the super high-end ones. At least that's what i learned after trying to use mine as a spindle sander, and having the chuck fly off the quil at 2,300rpms.
#1) Find someone with a thickness planer. note that the biggest ones you can buy at big-box stores would be a Dewalt, and that can only handle 13" wide pieces of wood. Perhaps an issue with a bolt-on, but I suppose for neck-through, they should be well narrower if it's already cut in half.
#2) hand plane. One should learn how to use one anyway. Probably 20 mins on each half at the most, and you're done.
#3) Router sled, if you have a router, you could build a simpler version of a router sled. You might need a new router bit designed for this type of cut.
#4) belt sander, and a ton of time and a huge mess of super fine sawdust. Ha!
- Gold Carvinite
- Posts: 1102
- Joined: Oct 2010
- Location: Omnipresence nearly achieved!
One can also build a sled for a circular saw (or use a radial arm saw), and very slowly make cuts to essentially plane stuff. I've done this before, as it was the only method I had. Painfully slow, almost as bad as sanding, but the overall precision is quite good, especially with a radial arm. Those saws are super fun to also pin someone in and play pranks on (oh, wait, wrong area).
Guitar theorem: G=X+1 where G= guitars one needs, and X = guitars one has.
Do or do not; there is no understand.
- Posts: 19
- Joined: Jul 2008
- Location: Concord, NC
- Posts: 1
- Joined: Apr 2018
Who is online
Users browsing this forum: No registered users and 2 guests